Temperature control, built into the bed you already own.
A Control Unit. A Mattress Pad. A loop of water.
Nothing else to learn.
Two parts. One system.
RECONNECT changes the temperature of the sleep surface directly, using water circulating through a low-profile Mattress Pad.
-
RECONNECT Sleep SystemThe complete system: Control Unit, Mattress Pad and the water between them.
-
The Control UnitSits beside the bed. Holds the water, cools or warms it and keeps it moving. Six touch controls live on the Unit: Timer, Zone, Temperature Down, Temperature Up, Mode and Power.
-
The Mattress PadLies on your mattress under the fitted sheet. Fine tubing carries the water across your sleep surface.
One closed loop. Warm to cool.
Water is the whole idea. It transfers heat efficiently, making it well suited to moving temperature through the bed.
Unit conditions the water
The Control Unit cools or warms the water to your setting.
Water enters the Pad
A pump sends it out through the tubing.
Water moves through the tubing
Fine tubing spreads the temperature across the bed.
Water returns to the Unit
The loop repeats and the setting holds.
Cooling. Felt in the bed.
RECONNECT cools the water, and the water cools the bed. The temperatures shown are water settings, and it works best in a comfortably cool bedroom.
-
Water temperatureCooling settings run from 54 to 95°F (12 to 35°C).
-
Your room and bedding matterThe surface you feel depends on the room, your mattress and what is on top.
-
Relative to the roomUnder suitable room conditions, the Unit can cool the circulating water by up to about 22°F (12°C) below room temperature.
Heating. On your terms.
The same loop works in reverse. The Control Unit warms the water and the bed follows.
-
Water temperatureHeating settings run from 77 to 131°F (25 to 55°C).
-
Start aheadAllow 30 to 45 minutes to reach your setting.
-
Keep it sensibleAvoid higher settings than you need, and avoid long contact with very high temperatures.
One bed. Two climates.
Both Queen and King include two independently adjustable zones from one Control Unit.
-
Two independently adjustable zonesEach side can have its own temperature setting.
-
Switch one side offUse one side or both, from the same Control Unit.
-
One ruleBoth sides must be cooling or both heating, within 14°F (8°C) of each other.
Changes through the night. Without tracking you.
Smart Rhythms runs a preset nine-hour temperature program from the moment you start it. The setting changes automatically through the night without sensors, sleep tracking or an app.
Shown as Auto Sleep on the Unit.
-
A preset nine-hour programRuns from the moment you start it.
-
No sensors, no sleep trackingIt follows a fixed program. It does not react to you.
-
On the UnitShown as Auto Sleep. Custom and Turbo are the other two modes.
About 20 minutes. Once.
Lay the Pad
Flat on your mattress, corners snug.
Connect the Unit
Plug in and push the tubing into the ports.
Fill water
Top up until the alert stays off.
Choose a mode
Custom, Turbo or Smart Rhythms.
Make the bed
Fitted sheet over the Pad, then your bedding.
Press start. Then sleep.
After setup, everything you use day to day is controlled directly from the Control Unit.
-
Start aheadPress start 30 to 60 minutes before bed to pre-cool or pre-heat.
-
TimerSet 1 to 12 hours. The Unit shuts off automatically after 12 hours.
-
Six physical controlsTimer, Zone, Temperature Down, Temperature Up, Mode and Power are all on the Unit. A child lock prevents accidental presses.
Ready when you are.
Temperature-controlled sleep, built around the bed you already own.
Direct control · Smart Rhythms · Two climates.